IDEC FC5A-F2M2 User Manual page 18

3: I
NSTALLATION AND
This chapter describes how to install and wire the PID modules. For general methods and precautions for
installation and wiring of the PID modules, see chapter 3 in the FC5A MicroSmart user's manual (FC9Y-B1268).
Be sure to use the PID modules properly after understanding installation and wiring thoroughly.
Caution
• Assemble the CPU module and PID modules before installing them on a DIN rail.
• Do not lay out or wire the modules while power is supplied to them. Otherwise, they
• When installing modules, follow the instructions described in the FC5A MicroSmart
Mounting Hole Layout for Direct Mounting on Panel Surface
To mount the PID module on a panel surface,
use the direct mounting strip and two M4 screws
(6 or 8 mm long).
For details about the direct mounting strip, see the
FC5A MicroSmart user's manual (FC9Y-B1268).
FC5A MicroSmart PID Module User's Manual FC9Y-B1283
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
W
IRING
Otherwise, they may break.
may be damaged.
user's manual. If there are flaws in the installation, it may cause disattachment,
failure or malfunction.
I W
NSTALLATION AND IRING
Direct mounting strip
FC4A-PSP1P
(All dimensions in mm)
3-1