Table of Contents
Advertisement
C
PID M
ONFIGURING
ODULE USING
PID Module Monitor Settings dialog box
(1)
(2)
(3)
(4)
(1) CH0 Trace Color Selection
Select the color for the three parameters to be traced.
(2) CH0 Trace Selection
Select the parameter to be traced. If none of the three parameters are selected, CH0 parameters are not
traced and only parameters are monitored.
(3) CH1 Trace Color Selection
Select the color for the three parameters to be traced.
(4) CH1 Trace Selection
Select the parameter to be traced. If none of the three parameters are selected, CH1 parameters are not
traced and only parameters are monitored.
(5) Auto Scaling
If the auto scaling is enabled, the range of the vertical axis is automatically updated in accordance with the
process variable (PV), set point (SP) and output manipulated variable (MV).
(6) Upper Limit
The upper limit of the vertical axis for the trace can be specified.
(7) Lower Limit
The lower limit of the vertical axis for the trace can be specified.
(8) Trace Time Settings
Interval:
Configure the interval time for the tracing between 1 to 60 seconds
×600:
Interval × 600 = Trace range
Example: If the interval time is 1 sec, the trace range will be 600 sec. When the traced data
reaches the right edge, the first half of the traced data is cleared, and the trace continues.
×9000:
Interval × 9000 = Trace end time
Example: If the interval time is 1 sec, the trace end time will be 9000 sec. The trace will be finished
in 150 minutes.
×27000:
Interval × 27000 = Trace end time
Example: If the interval time is 1sec, the trace end time will be 27000 sec. The trace will be
finished in 450 minutes.
6-54
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
W
LDR
IND
FC5A MicroSmart PID Module User's Manual FC9Y-B1283
(5)
(6)
(7)
(8)
Advertisement
Table of Contents
