Wireless Opentherm Bridge (R8810) - Honeywell ATC928G3000 Manual

Wi-Fi evohome Controller
(ATC928G3000)
To bind a OpenTherm Bridge (R8810) to a Wi-Fi evohome Controller
(ATC928G3000) to control an OpenTherm™ boiler...
On the evohome Controller
Press and hold SETTINGS
1
Press the green tick
2
Press SYSTEM DEVICES
3
Press BOILER CONTROL
4
Press OPENTHERM BRIDGE
5
On the OpenTherm Bridge
Press and hold the button for 15 seconds
6
(until the red LED blinks rapidly) to
clear any previous binding data
Press and hold the button again for 5
7
seconds (until the red LED blinks slowly)
Wi-Fi evohome Controller (ATC928G3000)
for 5 seconds
Wireless OpenTherm
Bridge (R8810)
On the evohome Controller
Press the bind button
8
You should receive a SUCCESS message on
the evohome Controller and the LED on the
Wireless OpenTherm Bridge should stop blinking
and turn OFF. If not, go back and re-bind.
19