Room Temperature Sensor (Hcw82) - Honeywell ATC928G3000 Manual

Wi-Fi evohome Controller
(ATC928G3000)
To bind a Room Temperature Sensor (HCW82) to a Wi-Fi evohome Controller
(ATC928G3000) as the room temperature sensor in a zone...
On the evohome Controller
Press and hold SETTINGS
1
Press the green tick
2
Press ZONE CONFIGURATION
3
Press on the required zone
4
Press TEMPERATURE SENSOR
5
Press REMOTE SENSOR
6
Press the green tick
7
Wi-Fi evohome Controller (ATC928G3000)
for 5 seconds
Room Temperature
Sensor (HCW82)
On the Room Temperature Sensor
Press the bind button on the bottom
8
right hand corner of the unit once
– the red LED light will flash
You should receive a SUCCESS message on the
evohome Controller. If not go back and re-bind.
11