Wireless Opentherm Bridge (R8810) - Honeywell ATC928G3000 Manual

Wi-fi evohome controller
Hide thumbs Also See for ATC928G3000:
Table of Contents

Advertisement

Programmer or Timer
(ST9000RF)
To bind a Wireless OpenTherm Bridge (R8810) to a Programmer
or Timer (ST9000RF) to control an OpenTherm™ boiler*...
On the Programmer or Timer
Move the setting slider to
1
Press and hold
1
seconds – it should briefly show "BIND MENU"
Press
until
and
2
are flashing on the display
Press and hold
for 8 seconds to
3
clear any previous bind data – it should
show "RESET" for a few seconds
Press
once
4
*only available on specific models and/or system configurations
58
Wireless connectivity Guide
RUN
and
together for 8
BOILER
Wireless OpenTherm
Bridge (R8810)
On the Wireless OpenTherm Bridge
Press and hold the button for 15 seconds
5
(until the red LED blinks rapidly) to
clear any previous binding data
Press and hold the button again for 5
6
seconds (until the red LED blinks slowly)
You should receive a COMPLETE message on
the Programmer or Timer and the LED on the
Wireless OpenTherm Bridge should stop blinking
and turn OFF. If not go back and re-bind.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents