Wireless Opentherm Bridge (R8810); Press The Up And Down Arrows Together For 3 Seconds - It Should Display 'Inst; Press The Down Arrow - It Should Display 'Cont; Press The Up Arrow Three Times - It Should Display 'Clr - Honeywell ATC928G3000 Manual

Digital Room
Thermostat (DTS92)
To bind a OpenTherm Bridge (R8810) to a Digital Room
Thermostat (DTS92) to control an OpenTherm™ boiler...
On the OpenTherm Bridge
Press and hold the button for 15 seconds
1
(until the red LED blinks rapidly) to
clear any previous binding data
Press and hold the button again for 5
2
seconds (until the red LED blinks slowly)
On the Digital Room Thermostat
Press and hold the power button
3
seconds to put the unit into standby
Press the up and down arrows together
4
for 3 seconds - it should display 'INst'

Press the down arrow - it should display 'COnt'

5
Digital Room Thermostat (DTS92)
for 2
Wireless OpenTherm
Bridge (R8810)
Press the up arrow three times
6
- it should display 'CLr'
Press the power button
7
clear any previous binding data

Press the up arrow - it should display 'COnt'

8
Press the power button
9
to send the binding signal to the
Wireless OpenTherm Bridge
The LED on the Wireless OpenTherm
Bridge should stop blinking and turn
OFF. If not go back and re-bind.
once to
once
39