Room Temperature Sensor (Hcf82) - Honeywell ATC928G3000 Manual

evohome Controller
(ATC928G2000)
To bind a Room Temperature Sensor (HCF82) to an evohome Controller
(ATC928G2000) as the room temperature sensor in a zone...
On the evohome Controller
Press and hold SETTINGS
1
Press the green tick
2
Press ZONE SETTINGS
3
Press EDIT ZONE
4
Press on the required zone
5
Press the button next to "Sensor:"
6
REMOTE RF DEVICE'S SENSOR
Press
7
evohome Controller (ATC928G2000)
for 5 seconds
Room Temperature
Sensor (HCF82)
On the Room Temperature Sensor
Press the bind button on the bottom
8
right hand corner of the unit once – the
red LED light will flash once to indicate
the binding signal has been sent.
You should receive a SUCCESS message on the
evohome Controller. If not go back and re-bind.
27