Digital Room Thermostat (Dts92); On The Digital Room Thermostat - Honeywell ATC928G3000 Manual

Programmer or Timer
(ST9000RF)
To bind a Digital Room Thermostat (DTS92) to a Programmer
or Timer (ST9000RF) as a room temperature sensor...
On the Programmer or Timer
Move the setting slider to
1
Press and hold
2
side) MODE together for 8 seconds – it
should briefly show "BIND MENU"
Press until
3
are flashing on the display
Press and hold for 8 seconds to
4
clear any previous bind data – it should
show "RESET" for a few seconds
Press once
5

On the Digital Room Thermostat

Press and hold for 2 seconds
6
to put the unit into standby
54
Wireless connectivity Guide
RUN
, and (right hand
SENSOR
and
Digital Room
Thermostat (DTS92)
Press and together for 3
7
seconds – it should display 'INst'
Press – it should display 'COnt'
8
Press three times – it should display 'CLr'
9
Press once to clear any previous binding data
10
Press – it should display 'COnt'
11
Press once to send the binding
12
signal to the Programmer or Timer
You should receive a COMPLETE message on
the Programmer or Timer and the LED on the
Digital Room Thermostat should stop blinking
and turn OFF. If not go back and re-bind.