Wireless Opentherm Bridge (R8810) - Honeywell ATC928G3000 Manual

Single Zone Thermostat
(T87RF)
To bind a OpenTherm Bridge (R8810) to a Single Zone
Thermostat (T87RF) to control an OpenTherm™ boiler...
On the OpenTherm Bridge
Press and hold the button for 15 seconds
1
(until the red LED blinks rapidly) to
clear any previous binding data
Press and hold the button again for 5
2
seconds (until the red LED blinks slowly)
On the Single Zone Thermostat
Press and hold on the left touch
3
zone (just below and to the left of the
display) for approximately 10 seconds
until a flashing 'Bo' is displayed
44
Wireless connectivity Guide
4
5
The LED on the Wireless OpenTherm
Bridge should stop blinking and turn
OFF. If not go back and re-bind.
Wireless OpenTherm
Bridge (R8810)
Turn the dial clockwise until a
flashing 'Co' is displayed
Press the left touch zone once
to send the binding signal to the
Wireless OpenTherm Bridge