Radiator Controller (Hr80) - Honeywell ATC928G3000 Manual

Wi-Fi evohome Controller
(ATC928G3000)
To bind a Radiator Controller (HR80) to a Wi-Fi evohome
Controller (ATC928G3000) "radiator valve" zone...
On the evohome Controller
Press and hold SETTINGS
1
Press the green tick
2
Press ZONE CONFIGURATION
3
Press on the required zone
4
Press RF DEVICE BINDING
5
Press the forward arrow
6
On the Radiator Controller
Press the recessed bind button on the
7
underside of the Radiator Controller – it should
briefly show a flashing RF icon
Wi-Fi evohome Controller (ATC928G3000)
for 5 seconds
then SYNC.
Radiator Controller
Press the recessed bind button again – it
8
should show a flashing RF icon
On the evohome Controller
Press the bind button
9
The evohome Controller will not show a SUCCESS
message. It's recommended to perform a
quick functional check to validate the bind.
To do this, adjust the setpoint temperature on
the evohome controller for that zone to the
maximum and minimum, checking the radiator
controller responds to the new setpoint.
(HR80)
9