Wireless Relay Box (Bdr91) - Honeywell ATC928G3000 Manual

Digital Room
Thermostat (DTS92)
To bind a Wireless Relay Box (BDR91) to a Digital Room
Thermostat (DTS92) to control a boiler...
On the Wireless Relay Box
Press and hold the button for 15 seconds
1
(until the red LED blinks rapidly) to
clear any previous binding data
Press and hold the button again for 5
2
seconds (until the red LED blinks slowly)
On the Digital Room Thermostat
Press and hold the power button
3
seconds to put the unit into standby
Press the up and down arrows together
4
for 3 seconds - it should display 'INst'
38
Wireless connectivity Guide
5
6
7
8
9
for 2
The LED on the Wireless Relay Box should stop
blinking and turn OFF. If not go back and re-bind.
Wireless Relay Box
Press the down arrow - it should display 'COnt'
Press the up arrow three times
- it should display 'CLr'
Press the power button
clear any previous binding data
Press the up arrow - it should display 'COnt'
Press the power button
binding signal to the Wireless Relay Box
(BDR91)
once to
once to send the