Wireless Relay Box (Bdr91) Sundial Valve - Honeywell ATC928G3000 Manual

Programmer or Timer
(ST9000RF)
To bind a Wireless Relay Box (BDR91) to a Programmer or
Timer (ST9000RF) to control a sundial valve*...
On the Programmer or Timer
Move the setting slider to
1
Press and hold
1
side) MODE together for 8 seconds – it
should briefly show "BIND MENU"
Press until
2
(Hot Water valve) and
are flashing on the display
Press and hold for 8 seconds to
3
clear any previous bind data – it should
show "RESET" for a few seconds
Press once
4
*only available on specific models and/or system configurations
Central Heating Timer (ST9000RF)
RUN
, and (right hand
(Heating valve) or
CONTROL
Wireless Relay Box
On the Wireless Relay Box
Press and hold the button for 15 seconds
5
(until the red LED blinks rapidly) to
clear any previous binding data
Press and hold the button again for 5
6
seconds (until the red LED blinks slowly)
You should receive a COMPLETE message
on the Programmer or Timer and the LED on
the Wireless Relay Box should stop blinking
and turn OFF. If not go back and re-bind.
(BDR91)
57