Single Zone Thermostat (T87Rf) - Honeywell ATC928G3000 Manual

evohome Controller
(ATC928G2000)
To bind a Single Zone Thermostat (T87RF) to an evohome Controller
(ATC928G2000) as the room temperature sensor in a zone...
On the evohome Controller
Press and hold SETTINGS
1
Press the green tick
2
Press ZONE SETTINGS
3
Press EDIT ZONE
4
Press on the required zone
5
Press the button next to "Sensor:"
6
REMOTE RF DEVICE'S SENSOR
Press
7
On the Single Zone Thermostat
Press and hold on the left touch zone (just below
8
and to the left of the display) for approximately
10 seconds until a flashing 'Bo' is displayed
evohome Controller (ATC928G2000)
for 5 seconds
Thermostat (T87RF)
Turn the dial clockwise until a
9
flashing 'Co' is displayed
Press the left touch zone once to send the
10
binding signal to the evohome Controller
You should receive a message on the evohome
Controller to say the binding signal was
received. If not go back and re-bind.
Single Zone
29