Using Your Machine As A Copier; Error Correction Mode (Ecm) - Ricoh FAX4000L Operator's Manual

4 ADVANCED FEATURES
3-4 Using Your Machine as a Copier
To make a single copy of a document, place the sheets in the feeder face down and press Copy .
To make more than one copy of a document, use Function 77.
1. Make sure the machine is in 4.
standby mode.
READY 100% 02 30PM
SET DOCUMENT
z. PreSS I Function I
I
7 7 I ~Yes .
MULTI COPY
SET DOCUMENT
5.
3. Place the sheets in the feeder
face down.
Shuffle the stack
Align
the edges
. Not more than 50 pages
KEY PA DI COPY
01 SETS
How many copies do you need ?
Example: 12 copies
Press 1 2 I .
COPY/N
12 SETS
Press 1 No 1 if you made a mistake. You
can make up to 99 copies.
Press 1COPY ~ .
The sheets are all scanned and stored.
Then the copies are printed.
Then the documents are cleared from
memory.
3-5 ECM (Error Correction Mode)
ECM (Error Correction Mode) is a recently developed signaling system which greatly reduces the
possibility of data being lost as a result of bad telephone lines. You should switch on ECM if you
frequently communicate over poor telephone lines. Using ECM, telephone charges are not affected,
and may even be reduced, unless you encounter a bad line. In this case, the extra signaling involved
will increase line charges but data will be transmitted much more reliably.
When transmitting from the memory, pages that are not sent correctly will be resent automatically,
even if ECM is disabled. However, ECM is a more efficient way of resending damaged data, as only the
damaged parts of the data will be resent. Also, the maximum possible number of retransmission
attempts is much higher.
After receiving using ECM, if DATA IN ECM MEMORY is displayed, your printer is jammed or out of
paper or toner. Do not switch off the machine or the data will be lost. The data will be printed after you
clear the problem (see page 96, 97 or 11 3).
Continued on the next page