Ricoh FAX4000L Operator's Manual page 17

2 INSTALLATION
5.
6.
7.
8.
SELECTOR KEYS
Halftone Indicator and Key
If you are transmitting a photograph, press
the key to light the Halftone indicator.
Contrast Indicators and Key
The indicator that is lit shows the contrast
that is now selected. Press the key if you
wish to change the setting.
Resolution Indicators and Key
The indicator that is lit shows the resolution
that is now selected. Press the key if you
wish to change the setting. Group 1 mode
can also be selected using this button.
Memory Indicator and Key
If the indicator is lit, the document will be
stored to the memory before it is trans-
mitted. If it is not lit, the document will be
sent immediately, without being stored.
Press the key if you wish to change the set-
ting.
STOP, COPY, AND START KEYS
Stop Key
Press this to stop the machine during com-
munication and return it to standby.
Copy Key
Press this key to copy the page(s) now in
the feeder. You can do this to check
whether your contrast, resolution, and half-
tone settings are appropriate.
Start Key
Press this to start transmission.
TEN-KEY PAD
Acts as a telephone keypad. Also used for
entering other numbers, such as Speed
Dial Codes, depending on the mode in use.
KEYS
Speed Dial Key
Press this when you wish to dial using a
Speed Dial Code.
Voice Request Indicator and Key
Press this key during fax communication if
you wish to talk to the person at the other
end on the same call.
On Hook Dial Indicator and Key
To make a phone call, press this key then
dial on the ten-key pad. There is no need to
pick up the handset during dialing.
Pause/Redial Key
When entering a telephone number at the
ten-key pad, press this key when you need
to entera pause. Also, press this key when
you wish to redial the last number that was
dialed.
Clear Key
This is used during programming to clear
the last character entered, or to clear the
character at the cursor, depending on the
mode in use.
9. QUICK DIAL KEYS
You can program each of these to dial a
number, a group of numbers or enter a se-
quence of numbers and settings, with just
one touch. You can also use these keys to
enter and edit labels, such as the RTI, TTI,
and CSI.
10. USER FUNCTION KEYS
Each of these keys can be programmed to
execute a function from the function list.
11. MODE SELECTOR KEYS
Polling Indicator and Key
If you want to use polling, press this key to
light the indicator.
Transfer Request Indicator and Key
If you want to use transfer request, press
the key to light the indicator.
Confidential Indicator and Key
If you want to send a confidential message,
press this key to light the indicator.
Send Later Indicator and Key
If you want to use send later, press this key
to light the indicator.
Stamp Indicator and Key
When the indicator is lit, each successfully
transmitted page will be stamped. Press
this key to enable or disable the stamp.
Reception Mode Indicators and Key
This indicator that is lit shows which mode
has been selected. Press the key to change
the mode.
16