Chapter 4 Procedures Before Operation - Mitsubishi Electric MELSEC-L SERIES Basic User Manual

CHAPTER 4
This chapter describes how to connect an E71 to Ethernet. For how to communicate with connected devices after the
E71 is connected, refer to the communication procedure. (
Checkbox
System consideration
Design the system configuration of the E71.
Installation
Connect the E71.
Connect an Ethernet cable to the E71.
Setting parameters
Set the following parameters, which are required to start up
the E71, from the programming tool.
Basic setting
Ethernet operation setting
Restarting the CPU module
Reflect the parameter settings by turning off and on the CPU
module or resetting the CPU module.
Network diagnostics
Check that the cables are connected properly or that
communications are performed properly with the set
parameters. (PING test, loopback test)
Continued to COMMUNICATION PROCEDURE (
PROCEDURES BEFORE OPERATION
Wiring
Page 64, CHAPTER 7)

CHAPTER 4 PROCEDURES BEFORE OPERATION

Page 64, CHAPTER 7)
Page 27, CHAPTER 3,
Page 57, CHAPTER 5
Page 25, CHAPTER 2,
Page 61, Section 6.1
Page 58, Section 5.2,
Page 62, Section 6.2
Page 66, Section 7.1.2,
Page 67, Section 7.1.3
MELSEC-L CPU Module User's
Manual (Hardware Design,
Maintenance and Inspection)
Page 322, Appendix 5
4
55