Appendix 4
The initial process is for enabling data communications with connected devices by setting the minimum number of
parameters for the E71.
In the MELSEC-L series, the initial process is performed automatically.
(1) Checking the initial process result
The results of the initial process can be checked using the LEDs and I/O signals.
Initial process
Upon normal completion
Upon abnormal end
If the initial process is not normally completed, correct the set values of parameters listed in Chapter 7 and those
in the initial process setting parameter described in this chapter. After correcting the parameters, write them to the
CPU module again, power off and on the CPU module or reset the CPU module.
Appendix 4.1
Configure the setting in the initial setting window. Each setting time is calculated by "setting value 500ms".
Project window
"Ethernet" under "Network Type".
Initial Process
Initial normal completion
INIT.LED
ON
OFF
Setting the initial process
[Parameter]
[Network Parameter]
Initial abnormal end signal
signal
(X19)
ON
OFF
[Ethernet/CC IE Field]
button
APPENDICES
A
(X1A)
OFF
ON
Select
311