Mitsubishi Electric MELSEC-L SERIES Basic User Manual page 61

(2) 10BASE-T connection
To configure a system for 10BASE-T connection, use devices that meet the IEEE 802.3 10BASE-T standards.
Configuration device
Unshielded twisted pair
cable (UTP) or shielded
*2
twisted pair cable (STP)
Connector
Hub
*1 This applies when a repeater hub is used. For the number of levels that can be constructed when a switching hub is
used, consult with the manufacturer of the switching hub used.
*2 Data can be communicated with an E71 (between LJ71E71-100 modules). In addition, an E71 can be directly connected
to a GOT.
Remark
Consult a network specialist for required devices.
Straight cable
A Category 3, 4, or 5 straight cable or cross cable is usable.
Cross cable
RJ45 connector
10Mbps hub
Up to four levels of cascade connection can be configured.
CHAPTER 5 SYSTEM CONFIGURATION
Description

*1
5
59