Duplex Sensor And Input Sensor Removal - Konica Minolta Bizhub 4700P Service Manual

6.6.4

Duplex sensor and input sensor removal

1. Remove the left cover. See
2. Remove the right cover. See
3. Remove the rear door and cover. See
4. Remove the power supply. See
5. Remove the power supply shield. See
6. Remove the duplex. See
7. Disconnect the cable JDUPPI1 from the controller board.
8. Remove the two screws (A), and cut the cable near the frame to detach the sensors.
9. Remove the other half of the cable from the printer.
bizhub 4700P/bizhub 4000P Service Manual
Left cover removal.
Right cover removal.
Rear door and cover
Power supply removal.
Power supply shield
Duplex removal.
- 231 -
removal.
removal.