Tips On Using Labels; Tips On Using Transparencies - Konica Minolta Bizhub 4700P Service Manual

- Have metal clasps, string ties, or folding bars
- Have an interlocking design
- Have postage stamps attached
- Have any exposed adhesive when the flap is in the sealed or closed position
- Have bent corners
- Have rough, cockle, or laid finishes

Adjust the width guides to fit the width of the envelopes.
Note: A combination of high humidity (over 60%) and high printing temperature may wrinkle or seal
envelopes.

Tips on using labels

Print samples on the labels being considered for use before buying large quantities.
Note: Use only paper label sheets. Vinyl, pharmacy, and two-sided labels are not supported.
When printing on labels:

Use labels designed specifically for laser printers. Check with the manufacturer or vendor to verify
that:
- The labels can withstand temperatures up to 240°C (464°F) without sealing, excessive curling,
wrinkling, or releasing hazardous emissions.
- Label adhesives, face sheet (printable stock), and topcoats can withstand up to 172-kPa (25-psi)
pressure without delaminating, oozing around the edges, or releasing hazardous fumes.

Do not use labels with slick backing material.

Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a jam.
Partial sheets also contaminate the printer and the cartridge with adhesive, and could void the
printer and toner cartridge warranties.

Do not use labels with exposed adhesive.

Do not print within 1 mm (0.04 inch) of the edge of the label, of the perforations, or between die-
cuts of the label.

Make sure the adhesive backing does not reach to the edge of the sheet. Zone coating of the
adhesive should be at least 1 mm (0.04 inch) away from edges. Adhesive material contaminates
the printer and could void the warranty.

If zone coating of the adhesive is not possible, then remove a 2-mm (0.08-inch) strip on the leading
and driver edge, and then use a non-oozing adhesive.

Portrait orientation is recommended, especially when printing bar codes.

Tips on using transparencies


Print a test page on the transparencies being considered for use before buying large quantities.

Feed transparencies from the standard tray, or the multipurpose feeder.
bizhub 4700P/bizhub 4000P Service Manual
- 23 -