Konica Minolta Bizhub 4700P Service Manual page 186

2. Insert the cable with the contacts on the cable facing away from the locking actuator. Insert the
cable on top of the actuator.
3. Slide the locking actuator towards the connector, locking the cable into place. The cable should not
move when this step is performed. If the cable moves, open the actuator, reposition the cable, and
then close the actuator to the down position.
Low Insertion Force (LIF) connector
This FRU contains a Low Insertion Force (LIF) connector. Read the instructions before proceeding.
Warning—Potential Damage: When installing a cable into an LIF connector, care must be taken to
avoid bending the edges of the cables and damaging the contacts on the cables.
Inserting a cable into the LIF connector
1. Looking at the connector, take note on which side the contacts are located. Many boards will have
the word "contacts" stamped on them to indicate which side of the LIF has the contacts. When
bizhub 4700P/bizhub 4000P Service Manual
- 185 -