Konica Minolta Bizhub 4700P Service Manual page 47

200 paper jam messages
Error code Description
200.01 Input sensor covered during warm-up
sequence.
200.02 Input sensor covered too quickly.
200.03 Media did not reach input sensor from MPF.
200.05 Input sensor covered too long.
200.08 Page arrive at input senor at unexpected time.
200.09 Printhead did not receive proper motor
feedback to start laser servo.
200.10 Printhead motor not locked when media
reaches the input sensor.
200.11 Printhead motor fell out of lock after page
reaches the input sensor.
200.12 Printhead was not ready for media.
200.13 Media at input sensor is not the next media to
be imaged.
200.14 Media reached the input sensor before EP
was ready.
200.15 Input sensor covered too long. Source = [x].
200.16 Fuser drive stalled.
200.19 Page that was successfully picked from option
tray never reached the input sensor.
200.21 No response from paper port driver while
waiting for the source to deactivate the Input
Source Ready flag to indicate it has initiated
picking.
200.23 Laser servo never started due to potential
conflict with the transfer servo.
bizhub 4700P/bizhub 4000P Service Manual
- 46 -
Action
Go to Sensor (input) static jam service
Go to Sensor (input) early/late arriving service
check.
Go to Sensor (input) early/late arriving service
check.
Go to Sensor (input) early/late arriving service
check.
Go to Sensor (input) early/late arriving service
check.
Go to Sensor (input) image jam service
Go to Sensor (input) image jam service
Go to Sensor (input) image jam service
Go to Sensor (input) image jam service
Go to Sensor (input) image jam service
Go to Sensor (input) image jam service
Go to Sensor (input) image jam service
Go to Main drive motor control jam service
check.
Go to Sensor (input) early/late arriving service
check.
Go to Sensor (input) early/late arriving service
check.
Go to Sensor (input) image jam service
check.
check.
check.
check.
check.
check.
check.
check.
check.