Duplex Tests - Konica Minolta Bizhub 4700P Service Manual

2. Choose the desired port, and then choose the desired test.
Ports
Port 0
Port 1
Port 2
Port 3
Single Step Get Device
Single Step Set Feature
3. To exit the test, POR the printer.
4. If the test fails, replace the failing USB cable.
5.3.5

Duplex Tests

Quick Test
The Duplex quick test determines if the top margin at the back of a duplexed page is set correctly. This
test prints a duplexed version of the Quick test page that can be used to adjust the duplex top margin.
Use either Letter or A4 paper.
To run the Duplex quick test:
1. From the Diagnostics menu, navigate to:
Duplex Tests >Quick Test
2. Choose any of the following:
- Single—Prints a single Quick test page.
- Continuous—Continuously prints the Quick test pages until
The printer attempts to print the Quick test page from the default paper source. If the default paper
source supports only envelopes, then the page is printed from Tray 1.
The Quick test page contains the following information:
- General printer information, including current page count, installed memory, processor speed,
serial number, engine ID, and controller board ID
- Printer margin settings
- Printer revision levels
- Alignment diamonds at the top, bottom, and each side
- Horizontal lines for skew adjustment
3. Check the Quick test page for the correct offset between the placement of the first scan line on the
front and back side of a duplexed sheet.
bizhub 4700P/bizhub 4000P Service Manual
Tests
Test J
Test K
Test SEO NAK
Test Packet
Test Force Enable
- 150 -
is pressed.