Horizontal Sliding Contact Connector - Konica Minolta Bizhub 4700P Service Manual

3. Rotate the locking actuator to the locked position by pressing down on both ends of the actuator.
The cable should not move when this step is performed. If the cable moves, open the actuator,
reposition the cable, and then close the actuator to the down position.

Horizontal sliding contact connector

This FRU contains a horizontal sliding contact connector. Read the instructions before proceeding.
The horizontal sliding contact connector uses a slide locking actuator to lock the ribbon cable into the
Zero Insertion Force (ZIF) connector. The cable is inserted horizontally into the connector.
Warning—Potential Damage: When opening or closing this type of actuator, gently push or pull the
two tabs located on each end of the actuator. Do not close the actuator from the center of the actuator.
Do not use a screwdriver to open or close the actuator. Damage to the cable or connector could occur.
bizhub 4700P/bizhub 4000P Service Manual
- 183 -