Table of Contents
Advertisement
Tolerable Industrial Fluids and Chemicals
Not all fluid variants and brands have been tested.
The following industrial fluids and chemicals were evaluated and deemed tolerable for the
HS-360X:
• Motor/Engine Oil
• Automatic Transmission Fluid (ATF)
• Continuously Variable Transmission Fluid (CVT)
• Industrial De-Greaser (Engine Brite Heavy Duty)
• Brake Fluid (DOT4)
If the scanner comes in contact with the above fluids and chemicals frequently, Omron
Microscan recommended that you clean the outside of the scanner daily using the
approved cleaning agents listed on the previous page.
Cleaning the Scanner
Routinely cleaning the exit window is required. A dirty window may affect scanning accuracy.
Do not allow any abrasive material to touch the window.
To clean the scanner:
1. Dampen a soft cloth with one of the approved cleaning agents listed above or use
pre-moistened wipes.
2. Gently wipe all surfaces, including the front, back, sides, top and bottom. Never
apply liquid directly to the scanner. Be careful not to let liquid pool around the scanner
window, trigger, cable connector or any other area on the device.
3. Be sure to clean the trigger and in between the trigger and the housing (use a cotton-tipped
applicator to reach tight or inaccessible areas).
4. Do not spray water or other cleaning liquids directly into the exit window.
5. Wipe the scanner exit window with a lens tissue or other material suitable for cleaning
optical material such as eyeglasses.
6. Immediately dry the scanner window after cleaning with a soft non-abrasive cloth to
prevent streaking.
7. Allow the unit to air dry before use.
8. Scanner connectors:
a. Dip the cotton portion of a cotton-tipped applicator in isopropyl alcohol.
b. Rub the cotton portion of the cotton-tipped applicator back-and-forth across the
connector on the Omron Microscan scanner at least 3 times. Do not leave any
cotton residue on the connector.
c. Use the cotton-tipped applicator dipped in alcohol to remove any grease and dirt
near the connector area.
d. Use a dry cotton tipped applicator and rub the cotton portion of the cotton-tipped
applicator back-and-forth across the connectors at least 3 times. Do not leave any
cotton residue on the connectors.
HS-360X Handheld DPM Scanner User Manual
Maintenance and Technical Specifications
3-3
Advertisement
Table of Contents
