Table of Contents
Advertisement
Reconnect Attempt Beep Feedback
Reconnect Attempt Beep Feedback
Parameter # 559
When a scanner disconnects as it goes out of range, it immediately attempts to reconnect.
While the scanner attempts to reconnect, the green LED continues to blink. If the auto-reconnect
process fails, the scanner emits a page timeout beep (long low/long high) and stops blinking
the LED. The process can be restarted by pulling the trigger.
The Beep on Reconnect Attempt feature is disabled by default. When enabled, the scanner
emits 5 short high beeps every 5 seconds while the re-connection attempt is in progress.
Scan a programming symbol below to enable or disable Beep on Reconnect Attempt.
*
Disable Beep on Reconnect Attempt
(0)
Enable Beep on Reconnect Attempt
(1)
4-30
HS-360X Handheld DPM Scanner User Manual
Advertisement
Table of Contents
