Omron HS-360X User Manual page 31

HS-360X Wireless Scanner Beeper and LED Definitions
Event
Standard Use
Power up.
Scanning
Presentation Mode on.
Presentation Mode off.
A barcode was successfully
decoded.
Parity error.
A transmission error was detected
in a scanned symbol. The data is
ignored. This occurs if a unit is not
properly configured. Check option
setting.
Conversion or format error.
A <BEL> character is received
over RS-232.
Wireless Operation
Out of batch storage memory,
unable to store new barcode.
Radio Indications
Scanner inserted into a cradle
(may be disabled).
Bluetooth connection established. Low, high
Bluetooth disconnection event.
Bluetooth Page timeout; remote
device is out of range/not powered.
Bluetooth connection attempt was
rejected by remote device.
Bluetooth attempting reconnection. None
Bluetooth attempting reconnection
(default is disable).
Paging state indication
HS-360X Handheld DPM Scanner User Manual
Beeper Sequence
Low/medium/high beeps
None
None
Medium beep (or as configured)
Low/low/low/extra low beeps
Four long low beeps
Five long low beeps
High
Low, high, low, high
Low
High, low
Long low, long high
Long low, long high, long low, long
high
Five high
Six high
Data Capture
LED
Green
Green solid
No LED; green LED is turned off
Green flash
Red
Red
Red
None
Red
System LED: None
Radio LED: None
System LED: Green
Radio LED: Green (Stays on after
trigger hold for 3 seconds)
System LED: Red
Radio LED: Red (Stays on at
trigger pull)
System LED: Red
Radio LED: Red (Stays on at
trigger pull)
System LED: None
Radio LED: Red (Stays on at
trigger pull)
System LED: None
Radio LED: Red blinking
System LED: None
Radio LED: Red blinking
System LED: Blue (fast, fast, slow)
2-3