Table of Contents
Advertisement
Auto-Reconnect
Parameter # 604
In Bluetooth Keyboard Emulation (HID) mode, SPP Primary, and Cradle Host Mode, select a
re-connect option for when the scanner loses its connection with a remote device:
• Auto-reconnect on Barcode Data: The scanner auto-reconnects when you scan a
barcode. With this option, a delay can occur when transmitting the first characters. The
scanner sounds a decode beep upon barcode scan, followed by a connection, a page
timeout, a rejection beep, or a transmission error beep. Select this option to optimize
battery life on the scanner and mobile device. Note that auto-reconnect does not occur
on rejection and cable unplug commands.
• Auto-reconnect Immediately: When the scanner loses connection, it attempts to
reconnect. If a page timeout occurs, the scanner attempts reconnect on a trigger pull.
Select this option if the scanner's battery life is not an issue and you do not want a delay
to occur when the first barcode is transmitted. Note that auto-reconnect does not occur
on rejection and cable unplug commands.
• Disable Auto-reconnect: When the scanner loses connection, you must re-establish it
manually.
Auto-Reconnect on Barcode Data
Disable Auto-Reconnect
HS-360X Handheld DPM Scanner User Manual
(1)
(0)
Radio Communications
* Auto-Reconnect Immediately
(2)
4-33
Advertisement
Table of Contents
