Table of Contents
Advertisement
HS-360X Wired Scanner Hands-Free Mode
The HS-360X scanner is in Hands-free (presentation) mode when it is placed in the HS-360X
Stand. In this mode, the scanner operates in continuous (constant-on) mode, where it
automatically decodes a barcode presented in its field of view.
When the scanner is not used for a user-definable period of time, it enters a low power mode
in which the LEDs are turned off or illumination blinks at a low duty cycle until the scanner
detects an image change (e.g. motion).
Scanning in Hands-Free (Presentation) Mode
The optional stand adds greater flexibility to HS-360X scanning operation. When the scanner
is seated in the scanner cup, the scanner's built-in sensor places the scanner in hands-free
(presentation) mode. When the scanner is removed from the stand, it automatically switches to
its programmed handheld triggered mode.
To operate the scanner in the HS-360X Stand:
1. Connect the scanner to the host (see the appropriate host chapter for information on
host connections).
Scanner Cup
HS-360X Wired Scanner in Hands-Free Mode
2. Insert the scanner in the HS-360X Stand by placing the front of the scanner into the
scanner cup.
3. Use the HS-360X Stand's adjustment knobs to adjust the height and angle of the scanner.
4. Center the symbol in the aiming pattern.
5. Upon successful decode, the scanner beeps and the LED turns green.
HS-360X Handheld DPM Scanner User Manual
Scanner Cup
Angle Adjustment
HS-360X Stand
Height Adjustment
Data Capture
2-9
Advertisement
Table of Contents
