Lock Override; Pairing Methods - Omron HS-360X User Manual

Scanner(s)-to-Cradle Support

Lock Override

Lock Override is applicable in Point-to-Point mode only (does not apply to Multipoint-to-Point
mode). In Multipoint-to-Point mode, if seven scanners are connected, the scanners must be
disconnected for a new scanner to connect.
Lock Override overrides a locked scanner base pairing and connects a new scanner. To use
Lock Override, scan the programming symbol below, followed by the pairing barcode on the cradle.
Lock Override

Pairing Methods

Parameter # 545
There are two pairing methods. The default method allows the scanner and cradle to pair
(connect) when the pairing symbol on the cradle is scanned. A second method pairs the
scanner and cradle when the scanner is inserted in the cradle. To enable this feature, scan
Enable Pair On Contacts below. With this feature enabled it is not necessary to scan the
pairing symbol on the cradle. If the pairing is successful, a low/high connection beep
sequence sounds a few seconds after the scanner is placed in the cradle. To enable or
disable pairing on contacts, scan the appropriate programming symbol below.
*
Enable Pair On Contacts
(1)
Disable Pair on Contacts
(0)
4-40
HS-360X Handheld DPM Scanner User Manual