Table of Contents
Advertisement
User Preferences Parameter Defaults
The table below lists defaults for user preferences parameters. To change the default values:
• Scan the appropriate programming symbols in this guide. These new values replace the
standard default values in memory.
• Configure the scanner using WebLink
See
Appendix A — Standard Default Parameters
and default parameters.
Parameter
User Preferences
Set Default Parameter
Parameter Barcode Scanning
Beep After Good Decode
Direct Decode Indicator
Beeper Volume
Beeper Tone
Beeper Duration
Suppress Power Up Beeps
Decode Pager Motor
Decode Pager Motor Duration
Low Power Mode
Time Delay to Low Power Mode
Timeout to Low Power Mode from Auto Aim (HS-360X
Wired Only)
Handheld Trigger Mode
Hands-Free Mode
Handheld Decode Aiming Pattern
Hands-Free (Presentation) Decode Aiming Pattern
Picklist Mode
FIPS Mode
(HS-360X Wired Scanner Only)
Continuous Barcode Read
Unique Barcode Reporting
Decode Session Timeout
Hands-free Decode Session Timeout
1. Parameter number decimal values are used for programming via RSM commands.
HS-360X Handheld DPM Scanner User Manual
User Preferences and Miscellaneous Options
.
PC
for all user preferences, hosts, symbologies,
Parameter
1
Number
236
56
859
140
145
628
721
613
626
128
146
729
138
630
306
590
402
736
649
723
136
400
Default
Restore Defaults
Enable
Enable
Disable
High
Medium
Medium
Do Not Suppress
Enable
150 msec
Enable (HS-360X Wireless Scanner)
Disable (HS-360X Wired Scanner)
100 ms (HS-360X Wireless Scanner)
1 Hour (HS-360X Wired Scanner)
15 Seconds
Level
Enable
Enable
Enable Hands-Free (Presentation)
Decode Aiming Pattern on PDF
Disabled Always
Disable
Disable
Enable
9.9 Seconds
15
5-3
Advertisement
Table of Contents
