Bluetooth Radio, Linking, And Batch Operation - Omron HS-360X User Manual

Bluetooth Radio, Linking, and Batch Operation

The HS-360X Wireless Scanner has a Bluetooth Class 1 radio which achieves a range of at
least 135m / 440ft (open air, line of sight). The actual range you achieve is influenced by the
presence of other radios, shelving and wall materials as well as which cradle is tested. The
environments vary widely and often influence radio ranges.
When the scanner goes out of communications range to the base, it can be configured for
Batch Mode. The scanner has sufficient on board memory to store 500 barcodes of typical
size (UPC/EAN).
Setting Up an iOS or Android Product To Work with the Scanner
Perform the following steps on each device to establish a link.
HID Keyboard Emulation
1. On the HS-360X Wireless Scanner, scan Keyboard Emulator (HID).
2. On an iOS/iPad/iPhone, select Settings > General > Bluetooth and turn Bluetooth
On. Choose the HS-360X Wireless Scanner from the list of discovered devices. A
link should be established allowing scanning into any application with keyboard entry.
3. On an Android/ET1/Droid, select Settings > Wireless and networks > Bluetooth (to
turn Bluetooth on, if not already on). Select Bluetooth Settings and choose the HS-360X
Wireless Scanner from the list of discovered devices. (The HS-360X Wireless Scanner
normally displays as HS-360X Wireless Scanner - xxxxxx, where xxxxxx is the serial number.)
Android devices, specifically the ET1, may require you to scan a PIN to connect. If so,
a PIN displays on the device. To enter the required PIN, scan the programming symbol,
then re-attempt connection. When a beep sounds, indicating the scanner is waiting for
PIN entry, scan the PIN using the
HS-360X Handheld DPM Scanner User Manual
Appendix H — Numeric
Radio Communications
Keyboard.
4-59