Connection Via A Hub - Mitsubishi Electric FX5 User Manual

4.2

Connection via a hub

In case of connection to Ethernet via hub, you must do CPU module settings and MELSOFT Product (engineering tool, etc.)
settings or GOT settings.
CPU module
Ethernet
Hub
Engineering tool Engineering tool
The flow up to start of Ethernet communication by the connection via a hub is as follows.
1.
Setting parameters
Create unit parameters with the engineering tool. (Page 24 Setting module parameters)
2.
Writing to the CPU module
Turn power OFF  ON or reset the system to enable the parameters. (Page 24 Writing to the CPU module)
3.
Connecting cables and external devices
Connect for Ethernet communication. (Page 16 Connection specifications)
4.
Setting the connection destination
Set connection destination with the engineering tool. (Page 25 Engineering Tool Settings)
For GOT settings, refer to the following manuals.
GOT2000 Series Connection Manual (Mitsubishi Products)
GOT1000 Series Connection Manual (Mitsubishi Products)
CPU module
GOT
4 CONNECTION WITH MELSOFT PRODUCT AND GOT
4.2 Connection via a hub
4
23