When Ethernet Cable Is Used (Connection Via A Hub) - Mitsubishi Electric MELSEC iQ-F FX5 User Manual

When Ethernet cable is used (connection via a hub)

To connect to Ethernet via a hub, setting of both the personal computer and the CPU module is required.
Connect a personal computer to the CPU module via a hub, following the procedure below.
Setting the CPU module
■Setting module parameters
From the engineer tool, set on the "Module Parameter Ethernet Port" screen.
Select [Parameter]  [FX5UCPU]  [Module Parameter]  [Ethernet Port]  [Basic Settings]  [Own Node Settings] on the
Navigation window.
(3) (3) (3)
■Writing to the CPU module
1.
Set the IP address on the CPU module side and click the
[Apply] button (1).
(1)
2.
Setting for connection.
Select [Basic Settings]  [External Device Configuration] 
[Detailed Setting]  [Ethernet Configuration (Built-in Ethernet Port)]
(2) (2) (2)
on the "Module Parameter Ethernet Port" screen.
3.
Drag and drop "MELSOFT Connection Module" from the
"Module List" to the left side of the screen. Select the protocol
corresponding to the external device in "Protocol" (3).
Write the parameters to be set in the CPU module.
Select [Online]  [Write to PLC] on the menu bar of the engineering
tool.
After writing the parameters to the CPU module, power off and on or
reset the CPU module to enable the parameters.
4 PROCEDURES BEFORE OPERATION
4.4 Connecting a Personal Computer
4
29