IP Address Change Function
This function is provided to change the IP address of the CPU module by setting the desired IP address to special registers
from a peripheral unit or another unit and turning ON a special relay.
This function changes the IP address of the CPU module even if no settings are made in GX Works3 PLC parameters.
Automatic detection of connected devices
Detects devices supporting iQSS which are connected to the CPU module (built-in Ethernet port), and automatically displays
them on "List of devices" and "Device map area" using an engineering tool.
Communication setting reflection of Ethernet device
Reflects the communication settings (such as IP addresses) in devices supporting iQSS in "Device map area" which are
connected over Ethernet.
Sensor parameter read/write
Reads/writes parameters from/to iQSS-compatible devices.