Mitsubishi Electric FX5 User Manual page 106

Logging into CPU module
This section describes the steps from starting FTP and logging into the CPU module.
Ex.
Start FTP from the Microsoft




 FTP start (FTP )
 Connect with FTP server (open CPU module IP address )
 Specify login name (login name )
 Specify password (password )
Use the login name and password that are set in "FTP Server Settings" under "Application Settings". When the CPU module
(FTP server) receives the login name and password from the external device (FTP client), it checks that the login name and
password are correct.
If the login name and password are correct, transfer of the files to the CPU module is permitted. If incorrect, file transfer is not
permitted.
Locking and unlocking the remote password
If the FTP communication port is specified as a remote password check target with the remote password setting, unlock the
remote password with the following command.
• quote password-unlock remote password 
When finished, lock the remote password with the following command.
• quote password-lock 
If the FTP communication port is specified as a remote password check target, some commands cannot be
used until the remote password is unlocked. For details on the commands that can be used in the locked
state, refer to the following.
Page 105 FTP command
Inputting the file password
If a file password is set for the target file, the file password must be input with the following command before the file can be
accessed.
• Write password (quote passwd-wr write password )
• Read password (quote passwd-rd read password )
8 FILE TRANSFER FUNCTION (FTP SERVER)
104
8.1 Data communication procedures
 
Windows command prompt.