Files That Can Be Transferred With Ftp; Ftp Command - Mitsubishi Electric FX5 User Manual

8.2

Files that can be transferred with FTP

The file transfer function (FTP server) enables transfer of files in the SD memory card installed on a CPU module.
For the files that can be transferred (read, write, deleted) with the file transfer function (FTP server), refer to the file operation
available which is described in the following manual.
MELSEC iQ-F FX5 User's Manual (Application)
8.3

FTP command

FTP command list
The FTP client side commands supported by the CPU module are shown below.
*1
: Executable , : Not executable
Command Function
binary Notifies that the file will be transferred without conversion.
bye Closes and ends the connection with the FTP server.
cd Change the CPU module current directory.
close Closes the connection with the FTP server.
delete Deletes the CPU module file.
dir Displays the CPU module file information.
get Reads a file from the CPU module.
ls Displays the CPU module file name.
mdelete Deletes the CPU module file.
mdir Stores the CPU module file information in the file.
mget Reads a file from the CPU module.
mls Reads a file from the CPU module.
mput Writes the file to the CPU module.
open Connects to the FTP server.
put Writes the file to the CPU module.
pwd Displays the current directory of the CPU module.
quit Closes and ends the connection with the FTP server.
quote Sends the FTP server's subcommand.
user Inputs the user name and password for the CPU module.
*1 The command may not be executed depending on the file type. (Page 105 Files that can be transferred with FTP)
*2 If executed, the process completes abnormally.
*3 Shows the "Allow Online Change" setting in "FTP Server Settings" under "Application Settings". If an illegal command is executed while
write is prohibited during RUN, the process completes abnormally.
*4 Shows whether the command can be executed when the FTP communication port performs a remote password check with the remote
password setting. For details on the remote password, refer to the following.
Page 133 Remote Password
*5 The parameter file and program file cannot be deleted when the CPU module is in the RUN state.
*6 Only the subcommands dedicated for the CPU module can be used. For the subcommands that can be used, refer to the following.
Page 106 Subcommands usable with quote command
*2
*6
CPU module status
STOP RUN
*3
Enable Disable
  
  
  
  
*5
  
  
  
  
*5
  
  
  
  
  
  
  
  
  
  
  
8 FILE TRANSFER FUNCTION (FTP SERVER)
8.2 Files that can be transferred with FTP
Remote password
*4 *4
Unlocked Locked
*3
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
105
8