Assembling The Corona-Star - WAGNER PEA-C4XL-S Translation Of The Original Operating Manual

VERSION 03/2014
OPERATING MANUAL
8.7

ASSEMBLING THE CORONA-STAR

The Corona-Star is a retrofi t set for the spray gun, which helps to achieve a better surface
quality (reduction of "orange peel").
Danger from electric current!
Risk of injury and damage to the device.
A
1
C
2
G
3
P_02337
ORDER NUMBER DOC2345334
WARNING
Only trained personnel may modify the Corona-Star.
Prior to assembling the Corona-Star, the high-voltage and the
powder feed must be switched off and secured against being
inadvertently switched on.
B
H
D E
Procedure:
1. Switch off the high-voltage and the powder
feed and
inadvertently switched on.
2. Unscrew the standard nut A from the spray
gun housing B.
3. Screw the new nut C for the Corona-Star D
onto the spray gun housing and tighten well.
4. Dismount the Corona-Star H from spray gun
housing B.
5. Fasten the cable guide onto the cover plate F
using screw E.
F
6. Slide the Corona-Star G onto the spray gun
housing B.
Note:
Check whether the grounding is assured.
7. The spray gun is ready for use again.
PEA-C4XL-S
secure them against being
50