Mounting The Corona-Star - WAGNER PEA-C4-HiCoat FM Operating Manual

4.6

Mounting the Corona-Star

The Corona-Star is a Retrofit-Set for the spray gun, which helps to achieve a better surface
quality (reduction of "orange peel").
Caution
Trained personnel may only carry out the assembling of the Corona-Star!
Prior to mounting the Corona-Star, the high voltage and the powder feed must be
switched off and secure against inadvertent switch on!
Proceed as described below:
1
2
G
3
Caution
Check whether the grounding is assured!
The spray gun is ready for use again.
26
A B
C
D E
Peac4_0012
0390882
Maintenance and cleaning
•
Switch off the high voltage and the powder
feed and secure against inadvertent switch
on.
•
Unscrew the standard nut A from the spray
gun housing B .
•
Screw the new Corona-Star nut D onto the
spray gun housing and fasten in place.
•
Fasten the cable guide onto the cover plate
F
F by using the screw E .
•
Slide the Corona-Star G onto the spray
gun housing B .
-
PEA-C4-HiCoat FM
0405_ .doc
01 / 2008