Performing A Paint Change - WAGNER PEA-C4XL-S Translation Of The Original Operating Manual

VERSION 03/2014
OPERATING MANUAL
7.7

PERFORMING A PAINT CHANGE

Dust formation!
Danger of poisoning.
Danger due to escaping dust, contamination of the device and
device components.
In the case of a paint change, powder residues must be thoroughly removed from all
powder-conveying parts. In the following, only the procedure for the powder spray gun
is described.
Note:
During a paint change, the nozzle system does not necessarily have to disassembled.
Paint carry-over!
If the union nut is not screwed on tightly up to the stop position, the paint may smear.
Procedure:
1. Switch off the powder coating system after an automatic fl ushing and secure it
against being switched back on.
2. In case no automatic fl ushing is used, fl ush the gun manually and remove any powder
residues from it before switching off the system:
- Disconnect the powder hose from the spray gun.
- Blow through the spray gun using the air gun and thus remove any powder
residues.
- Switch off the system and secure against unauthorized reactivation.
3. Before starting to connect the powder hose again, all parts carrying powder must be
thoroughly cleaned.
4. The spray gun is ready for use again.
ORDER NUMBER DOC2345334
WARNING
Before starting cleaning or other manual work, the high-voltage
must be shut down and locked to prevent it from being switched
back on!
During every paint change, the booth suction system and the
fi lter cleaning system must remain activated!
NOTICE
PEA-C4XL-S
33