Fitting The Round Spray Nozzle - WAGNER PEA-C4XL-S Translation Of The Original Operating Manual

VERSION 03/2014
OPERATING MANUAL
2
1
8.5

FITTING THE ROUND SPRAY NOZZLE

The standard Corona spray gun is delivered with a fl at spray nozzle. The nozzle can be
changed easily, as described below.
Note:
If changing from the fl at spray nozzle to the round spray nozzle with defl ector cone, the
depth control must be adjusted.
The C4 R electrode holder is necessary to perform the change.
2
1
P_00591
ORDER NUMBER DOC2345334
3
5
P_00700
3
5
5. After long periods of operation or having
replaced the protective wedge repeatedly, it is
also recommended to check the powder tube
for wear and replace if necessary.
You will fi nd the necessary wearing parts and
spare parts in Chapter 13 "Spare Parts" of this
operating manual.
6. Prior to re-fi tting, check whether the contact
points on electrode holder 3 and in gun housing
5 have been thoroughly cleaned so that the
electrode tip is electrically connected to the
high-voltage generator.
7. Carefully fi t electrode holder 3 in spray gun
housing 5.
8. Slide the fan spray nozzle 2 back over electrode
holder 3 and fasten in place using union nut 1.
Procedure:
1. Unscrew union nut 1 from gun housing 5.
2. Pull fl at spray nozzle 2 off electrode holder 3.
3. Carefully remove electrode holder 3 from gun
housing 5.
Note:
Do not damage the electrode holder, when pulling it
out and inserting it.
4. Remove powder residues from the parts
removed and from the spray gun.
PEA-C4XL-S
45