Mounting The Corona-Star - WAGNER PEA-C4 Twin-HiCoat Operating Manual

4.5

Mounting the Corona-Star

The Corona-Star is a Retrofit-Set for the spray gun, which helps to achieve a better surface
quality (reduction of "orange peel").
Caution
Trained personnel may only carry out the assembling of the Corona-Star!
Prior to mounting the Corona-Star, the high-voltage and the powder feed must be
switched off and secure against inadvertent switch on!
Proceed as described below:
1
2
G
3
Caution
Check whether the grounding is assured!
The spray gun is ready for use again.
22
A B
C
D E
Peac4_0012
390832
-
Maintenance and cleaning

Switch off the high-voltage and the powder
feed and secure against inadvertent switch
on.

Unscrew the standard nut A from the spray
gun housing B .

Screw the new Corona-Star nut D onto the
spray gun housing and fasten in place.

Fasten the cable guide onto the cover
F
plate F by using the screw E.

Slide the Corona-Star G onto the spray
gun housing B .
PEA-C4 Twin-HiCoat
0405_ .doc
09/2014