Dead Start Of Tractor In Regular Operation - Clutch Pedal; Dead Start - Using The Clutch Pedal - Zetor FORTERRA HSX 100 2014 Operator's Manual

DEAD START OF TRACTOR IN REGULAR OPERATION – CLUTCH PEDAL
In regular operation use the clutch pedal only for stopping the tractor.
For the need of delicate inching, e.g. when connecting the tools or when manipulating with tractor in crammed
spaces, if even the reduced gears are not slow enough, use the clutch pedal only for short time.
It is forbidden to control the speed of tractor by partial depression of clutch pedal
with engine revolutions higher than 1200 rpm.
Do not use the clutch pedal as a foot rest.
There is a risk of limited service life or failures of travel clutches.
DEAD START – USING THE CLUTCH PEDAL
1. Start the engine.
2. Depress the clutch pedal.
3. Select road and reduced speeds.
4. Shift an applicable gear for starting the tractor.
5. Shift the reversing lever to the direction requested (forward or backward).
6. Slightly increase the engine revolutions.
7. Prepare the manual brake for unbraking.
8. Release the clutch pedal only to the point of travel engagement and with simultaneous increase of revolutions continue in a
continuous release of the clutch pedal.
9. Fully unbrake the manual brake.
10. Start smoothly and slowly.
Use this way of dead start when you need to inch carefully, for example when connecting tools etc.
DRIVING OPERATION
73