Setting Automatic Disengagement Of Pto Shaft Clutch - Zetor FORTERRA HSX 100 2014 Operator's Manual

SETTING AUTOMATIC DISENGAGEMENT OF PTO SHAFT CLUTCH

Setting automatic disengagement of PTO shaft clutch is done with standing tractor with started engine, with disengaged PTO
shaft clutch switch and reversing lever under the steering wheel in neutral position.
Display the third display on dashboard by gradual depression of (A) button.
Setting H-LIMIT position
1. Set the arms of three-point hitch to a position of the required disengagement of rear PTO shaft clutch.
2. Press (C) button on the dashboard. By this a new value is saved and the number by H-LIMIT item changes and equals to
ACTUAL value.
Setting L-LIMIT position
1. Set the arms of the three-point hitch to the position of required engagement of rear PTO shaft clutch.
2. Press (D) button on the dashboard. By this a new value is saved and the number with L-LIMIT item changes and equals to
ACTUAL value.
The number by H-LIMIT item must be always greater at least by 10 than the number by L-LIMIT item, or the new value will not be
saved.
Beware! When setting the position of arms of automatic disengagement of rear PTO shaft clutch outside basic
values set by manufacturer not bearing any liability for damage incurred from this setting.
DRIVE OF AGRICULTURAL MACHINERY
119
FH12N081