Zetor FORTERRA HSX 100 2014 Operator's Manual page 69

2 - Clutch control button on the head of gear shifting lever
This way of control has the function of automatic switch of travel clutch.
When pressing the button of clutch control on the head of gear shifting lever there is release of travel clutch
When releasing the red button of control clutch on the head of gear shifting lever, there is a switch of travel clutch.
The rate of travel clutch switch is controlled by electronic control unit on the basis of information saved with calibration
and the operator cannot influence it.
3 - Clutch pedal
When depressing the clutch pedal, there is release of travel clutch.
When releasing the clutch pedal, there is a switch of travel clutch.
The speed of travel clutch switch is dependent on the speed of releasing the clutch pedal.
The clutch pedal does not enable the function of automatic dead start and operators influence the speed and smooth-
ness of dead start.
Use the clutch pedal only for stopping the tractor in regular operation.
For the need of delicate inching, for example when connecting tools or when manipulating with the tractor in
crammed spaces, when even the reduced gear speeds are not slow enough, use the clutch pedal for short time.
It is forbidden to control the speed of tractor by partial depression of the clutch pe-
dal with engine revolutions higher than 1200 revolutions per minute.
Do not use the clutch pedal as a foot rest.
There is a danger of limiting service life or failure of travel clutches.
DRIVING OPERATION
70