Table of Contents
Advertisement
Dead start of tractor in regular operation - automatic dead start function
Automatic dead start function is in the shift of reversing lever with engaged applicable gear followed by dead
start without using the clutch pedal or clutch control buttons.
1. Start the engine.
2. Shift appropriate gear for starting the engine.
3. Release the manual brake, if you are standing on a slope, brake the tractor by foot brake.
4. When shifting the reversing lever form neutral to the requested direction of tractor drive (forward or
backward), the tractor starts.
5. When you increase the engine revolutions simultaneously, release the foot brake.
When depressing the clutch pedal, the automatic dead start function is put off from operation.
Dead start of tractor in regular operation - clutch pedal
In regular operation use the clutch pedal only for stopping the tractor. For the need of delicate
inching, e.g. when connecting the tools or when manipulating with tractor in crammed spaces, if
even the reduced gears are not slow enough, use the clutch pedal only for short time.
It is forbidden to control the speed of tractor by partial depression of clutch pedal with engine
revolutions higher than 1200 rpm. Do not use the clutch pedal as a foot rest. There is a risk of limited
service life or failures of travel clutches.
1. Start the engine.
2. Depress the clutch pedal.
3. Select road and reduced speeds.
4. Shift an applicable gear for starting the tractor.
5. Shift the reversing lever to the direction requested (forward or backward).
6. Slightly increase the engine revolutions.
7. Prepare the manual brake for unbraking.
8. Release the clutch pedal only to the point of travel engagement and with simultaneous increase of
revolutions continue in a continuous release of the clutch pedal.
9. Fully unbrake the manual brake.
10. Start smoothly and slowly.
Use this way of dead start when you need to inch carefully, for example when connecting tools
etc.
Change the direction of drive
Change the direction of drive by means of reversing lever
The compliance of the following instructions when changing the tractor driving direction helps to
prolong the service life of travel clutches.
· Use the reversing lever under the steering wheel without using the clutch pedal to change the tractor driving
direction.
· Select the slowest speed L of the torque multiplier to change the tractor driving direction.
· Select a lower transmission gear with respect to the following acceleration and loading of the tractor to
change the tractor driving direction.
The change of the driving direction using the reversing lever is performed with the travel
speed lower than 10 km/hour!
1. Lower the travel speed of the tractor below 10 km/hour using the brake pedals.
2. Move the reversing lever to the required tractor driving direction.
3. The tractor automatically stops and starts driving in your required direction.
4. While increasing the engine revolutions continue in a smooth start of the tractor.
DRIVING OPERATION
52
Advertisement
Table of Contents
