Checking The Oil Level In The Engine; Draining Oil From The Engine; Replacing The Full-Flow Engine Oil Cleaner - Zetor FORTERRA HSX 100 2014 Operator's Manual

CHECKING THE OIL LEVEL IN THE
ENGINE
Check the oil level daily before starting
work with the tractor in the horizontal po-
sition. Unscrew the dipstick, wipe it with a
piece of cloth and screw it back in. After
repeated removal of the dipstick the oil
level must not drop below the lower
mark. Replenish oil
through the filling opening.
MAINTENANCE INSTRUCTIONS
H193

DRAINING OIL FROM THE ENGINE

Drain oil by unscrewing the drain plug
(3), best immediately after a drive or after
heating the engine to the working tem-
perature. Clean the drain plug before re-
turning it to its place. Check the sealing
ring for integrity.
as necessary
REPLACING THE FULL-FLOW
ENGINE OIL CLEANER
The cleaner is replaced at every engine
oil replacement. Before installing the new
cleaner clean the sealing surface of the
housing (1) and the cleaner (2). Coat the
rubber sealing with oil that you will fill the
engine with and tighten the cleaner by
hand. When the sealing gets in contact
with the block sealing, tighten the cleaner
again by 3/4 to 1 1/4 turns. Check the
cleaner for possible leaks after starting
the engine.
196
H195