Setting Up The Clutch Pedal Dead Motion; Bleeding The Clutch Hydraulic Circuit - Zetor 86 41 forterra turbo Operator's Manual

SETTING UP THE CLUTCH PEDAL
DEAD MOTION
The correct dead motion between the
pedal piston rod and the piston of the
main cylinder should not be set up for
having been adjusted by the manufac-
turer. What is set is the mutual positions
of the piston rod and the piston rod eye
(1) so that the piston rod is as pulled out
from the cylinder as possible while the
pedal leans against the upper stop
screw (2). Then lock with the nut (3) the
piston rod in position with respect to the
eye (3). After the setting up ensure that
the cylinder dust protecting sleeve is not
deformed and if necessary arrange it
with your hand.
SETTING-UP OPERATIONS
F_02_205
BLEEDING THE CLUTCH HYDRAULIC
CIRCUIT
For the bleeding proceed in the same
way as for that of the braking system.
The bleeding screw of the declutching
hydraulic circuit is located on the de-
clutching cylinder (1).
After two years of operation, the
brake liquid has to be exchanged
in the whole braking circuit in-
cluding the declutiching one.
F284
192