Setting Automatic Disengagement Of Pto Shaft Clutch - Display Description; Setting The Limits Of The Automatics Of The Three-Point Hitch; Automatic Disengagement Of Pto Shaft Clutch - Return To Basic Setting - Zetor PROXIMA GP Series Operator's Manual

PTO DRIVE OF AGRICULTURAL MACHINES

Setting automatic disengagement of PTO shaft clutch - display description

PHS18N021
Gradually press the buttons (C) and (D) to display the screen of automatic switching off of the PTO shaft on
the instrument panel.
The following values are displayed on the screen:
OFF-LIMIT (1) - position of arms of the rear three-point hinge where the clutch of PTO shaft is deactivated
ON (2) - the current position of arms of the rear three-point hinge
ON-LIMIT (3) - position of arms of the rear three-point hinge where the clutch of PTO shaft is activated
The values of individual items are percents from the total stroke of hydraulic arms, the maximum stroke is
100%.

Setting the limits of the automatics of the three-point hitch

Press the buttons (C) and (D) gradually to display the automatic PTO clutch disengage screen on the
instrument panel.
- Press and hold the Enter button to enter the 3-Point Hitch Learning Mode screen; for 7 seconds the
instructions for saving values will be displayed; the screen with instructions can be skipped by pressing the
Enter or Reset button.
- When entering the 3-Point Hitch Learning Mode screen, the OFF Limit and ON Limit values start flashing
and they can be overwritten.
- To save a new value, set the current 3-Point Hitch height to the desired position, which is displayed as
Actual pos.
- To save the new automatics switch-off value (OFF Limit), press the up arrow button (C) to enter the current
3-Point Hitch position value.
- To save the new automatics switch-on value (ON Limit), press the down arrow button (D) to enter the
current 3-Point Hitch position value.
- To exit the 3-Point Hitch Learning Mode screen and return to basic screen, press (A) Reset or Enter (B)
button.
- Change the stored limit values only when the PTO shaft is stationary.

Automatic disengagement of PTO shaft clutch - return to basic setting

The main values set by the manufacturer are as follows:
OFF LIMIT - 55
ON LIMIT - 45
If the screen is displayed, the main values are set by pressing the button (A) on the instrument panel.
109