Removal, installation
1
Remove the two hex. head bolts (55) in the
oil pan.
Installation note
Tightening torque 25 Nm.
2
Remove hex. head bolts (21) in end cover
Installation note
Coat threads on hex. head bolts with sealant
002 989 00 20 10.
Tightening torque 10 Nm.
3
Press end cover off of crankcase at tabs
(arrows) and remove crankshaft radial seal
from crankshaft journal.
Note
When pressing the end cover on and off avoid
damagingthe oil pan gasket. .
Installation note
Clean gasket residues off of parting surface on
end cover. Check crankshaft radial seal and re-
place if required. Coat parting surface on end
cover with sealant 002 989 00 20 10 and slide
end cover together with radial seal over attached
installation sleeve 601 589 03 43 00.
01.10 - 222/3
EXIT